PROFESSIONAL
TECHNICIANS(PERSONS)
+
ABOUT US
Chongqing Pigeon Electrical Porcelain Co., Ltd. is restructured from Chongqing Electrical Porcelain Factory, the main enterprise designated by the former Ministry of Machinery Industry to produce high-voltage electrical porcelain. It is invested and established by Chongqing Pigeon Electric Wire and Cable Co., Ltd. and affiliated to Chongqing Machinery Electronics Holding Group Co., Ltd. It was listed in Hong Kong in June 2008. As the backbone enterprise of the national electrical porcelain industry, it is also the largest high-voltage electrical porcelain ...
Composite Housed Gapless Zinc Oxide Arrester
The gapless zinc oxide arrester adopts zinc oxide resistor as the core component, which has excellent nonlinear volt-ampere characteristics, fast steep wave and large circulation capacity. The composite housed gapless zinc oxide arrester is molded by integral silicone rubber, which has the advantages of small volume, light weight, pollution resistance...
02
CONSULTATION HOTLINE:023-40768555
PRODUCT
40 kN Disc Suspension Porcelain Insulators
Note:description on XP-40C-1 and XP-40C-2 models: XP refers to a standard cap suspension porcelain insulator expressed by electromechanical failure load. The number after the first dash refers to the electromechanical failure load (kN), C refers to the slot connection, and the number after the second dash refers to the serial number of the design.
CONSULTATION HOTLINE:023-40768555
01
Composite Guy Strain Insulators
Composite Guy Strain Insulators are mainly used in terminal poles, corner poles, tension poles and long-span poles of lines. When the tension of the cable exceeds the allowable tension, the insulation layer will be destroyed, but two mutually perpendicular iron rings are connected inside to ensure that the cable will not be disconnected, avoiding the occurrence of ...
03
CONSULTATION HOTLINE:023-40768555
High Voltage Drop-out Fuse
High Voltage Drop-out Fuse is suitable for AC system with nominal voltage 3 kV and above and frequency 50 Hz. It should be installed in a place with ambient temperature from -40¡ãC to +40¡ãC, and altitude not more than 1,000 m. It is installed on the high voltage side of distribution ...
04
